A dimension is stated as 25 +/-0.02 mm in a drawing. What is the tolerance ?

6) The difference between the maximum and minimum sizes allowed in manufactured components is called :

Answer is:

Tolerance

Explanation:

Tolerance is defined as the difference between the maximum and the minimum sizes allowed in manufactured components.

7) The measured size of the dimension of a component is called

Answer is:

Actual size

Explanation:

The measured size of the dimension of a component is called Actual size.

8) A pin is fitted in a hole. The tolerance zone of the pin is entirely above of that hole. The fit obtained will be

Answer is:

Interference fit

Explanation:

If the tolerance zone of the pin is entirely above of that hole, then the fit obtained is called as interference fit.

Interference Fit Interference fit is defined as the fit established when a negative clearance exists between the sizes of the holes and the shaft. In Interference fit, the minimum permitted diameter of the shaft is larger than the maximum allowable diameter of the hole.

Examples for Interference Fit are: Bearing bushes, small end in the connecting rod.

9) Interchangeability is normally applied for

Answer is:

Mass production

Explanation:

Interchangeability is normally applied for Mass production.

Interchangeability occurs when one part in an assembly can be substituted for a similar part which has been made to the same drawing. Suppose there are 100 parts each with a hole, and 100 shafts which have to fit into any of the holes. If there is interchangeability then any one of the 100 shafts should fit into any of the holes and the required kind of fit can be obtained.

Hence, for the interchangeability of holes and shafts, we need a system of limits and fits which gives standard values for the limits on the hole and shaft, so that any particular type of fit can be obtained.

Interchangeability is possible only when certain standards are strictly followed.

In universal interchangeability the mating parts are drawn from any two different manufacturing sources. Universal interchangeability is desirable and to achieve this all standards used by various manufactures should be traceable to a single source which will be an international standard.

When all parts to be assembled are made in the same manufacturing unit,then local standards may be followed which is known as local interchangeability. The required type of fit in an assembly can be obtained either by universal or full interchangeability or by selective assembly.

For More Limits and Fits MCQ - Machinist(Set-1) with Answers

For more MCQ's Click Here

A dimension is stated as 25 +/-0.02 mm in a drawing. What is the tolerance ?

0.04 mm

For More Limits and Fits MCQ - Machinist(Set-1) with Answers

Related Limits and Fits MCQ - Machinist(Set-1) with Answers

6) The difference between the maximum and minimum sizes allowed in manufactured components is called :

Tolerance

7) The measured size of the dimension of a component is called

Actual size

8) A pin is fitted in a hole. The tolerance zone of the pin is entirely above of that hole. The fit obtained will be

Interference fit

9) Interchangeability is normally applied for

Mass production

For More Limits and Fits MCQ - Machinist(Set-1) with Answers