Sand wash is a casting defect which Occurs near the ingates as rough lumps on the surface of a casting.
Sand wash is a casting defect which Occurs near the ingates as rough lumps on the surface of a casting.
A casting defect which occurs near the in gates as rough lumps on the surface of a casting is known as sand wash.
A casting defect which occurs due to improper venting of sand is known as Blow holes.
In metalworking, a fuller is a tool used to form metal when hot. The fuller has a rounded, either cylindrical or parabolic, nose, and may either have a handle or a shank.
The shank of the lower fuller allows the fuller to be inserted into the hardy hole of the anvil.
1)Drawing Down: Drawing down is a process of elongate the length and reduce the cross section area of work piece. Simply in this operation, the length of work piece increases and the cross section area decreases. In this process, a compressive force is applied at perpendicular direction of its length axis. If a tensile force is applied to change its length at parallel to its length axis, this process is known as wire drawing.
2) Upsetting: Upsetting is just opposite operation to drawing down. In this operation, the length of work piece decreases and its cross section area increases. In this process, a compressive force is applied at parallel direction to its length axis.